SABnzbd package for PowerPC based DiskStations

Met dit pakket wordt SABnzbd geinstalleerd op de DiskStation. SABnzbd is een NZB leech programma met een web-interface die gemakkelijk te gebruiken is. Het stelt je DS in staat om dus te leechen van usenet! De bekende beperkende factor is echter de snelheid; op een 106e zul je het moeten doen met ~ 310 KBps

For our English users:
This package will install SABnzbd on your DiskStation. SABnzbd is a NZB leecher with a web-interface, making it easy to manage the server. It basically adds support for leeching from newsgroups! The known issue is the performance; it will only make it to approx. 310 KBps on a 106e.

Requirements for this patch:

- optware

Instructions

Installation:

- You have to place syno-sabnzbd.tar.bz2 in your 'public' directory of your DiskStations' share / ftp

- Open the DiskStations administration page in your webbrowser, and apply 'enable-sabnzbd.pat' as a firmware upgrade. Important note: this will fail with an exit code 42. This is done to fool the DiskStation, so it won't reboot after the patch.

- Open the SABnzbd page http://your-diskstations-ip:8080/sabnzbd/

Removal:

- Apply 'disable-sabnzbd.pat' as a firmware upgrade.

About & Credits

This 'firmware' does not contain a binary, like you usually find when upgrading firmware of some piece of hardware. Instead, this is just a  simple shell script, which makes the 'firmware' very low-risk to apply. As you might have noticed, the patch is a tarball file.

All credits go to:

http://oinkzwurgl.org/
http://www.nslu2-linux.org/
http://sabnzbd.sourceforge.net/


Download link:

http://www.synology-forum.nl/bestanden/ ... -0.2.4.zip
http://www.synology-forum.nl/bestanden/ ... -0.2.5.zip ('beta')

Ben blij te horen dat het werkt! Ik kon toch niet helemaal m'n NAS clean installeren; alle config files bleven staan . Alleen echt de hele disk schoonvegen leek mij de optie, maar dan moet ik al die GB's weer opnieuw backuppen